[tulip] Kingston KNE111TX Full Duplex LED

[John Connett]

John Connett wrote:
> 
> Donald Becker wrote:
> > There isn't a general patch that will work for all boards, but please
> > try adding the following two lines around line 780
> >
> >         /* BugFixes: The 21143-TD hangs with PCI Write-and-Invalidate cycles.
> >            And the ASIX must have a burst limit or horrible things happen. */
> >         if (chip_idx == DC21143  &&  chip_rev == 65)
> >                 tp->csr0 &= ~0x01000000;
> >         else if (tp->flags & IS_ASIX)
> >                 tp->csr0 |= 0x2000;
> > +       else if (chip_idx == PNIC2)
> > +               outl(0xf0000000, ioaddr + CSR9);
> >
> > If this setting isn't somewhere in the EEPROM I'll have to add a new
> > subsystem ID specific flag for this board.
> 
> Thanks for the swift reply.  I have tried this change applied to the
> v0.92t driver and it appears to have no effect.  The Full Duplex LED
> still flashes in time with the Activity LED but with a slight delay.

Don't know if this will help, but I inserted a printk to output the
value of CSR9 before and after the outl.  Here are the values:

    eth1: before: 0x00fecf00
    eth1: after : 0xf0fe87ff

--
John Connett (jrc@art-render.com)