Is this normal?

[Jay Thorne]

Max Freedom wrote:
> 
> When I boot, I see the following:
> 
>   The PCI BIOS has not enabled this device!  Updating PCI command
> 0000->0005.
> tulip.c:v0.89H 5/23/98 becker@cesdis.gsfc.nasa.gov
> eth0: Lite-On 82c168 PNIC at 0xfc00, 00 a0 cc 22 14 c0, IRQ 0.
> eth0:  MII transceiver found at MDIO address 1, config 3100 status 7829.
> eth0:  Advertising 01e1 on PHY 1, previously advertising 01e1.
> 
> But netstat -i only shows the loopback interface. I tried 0.90, and it
> did the same thing. I also tried increasing the logging level and
> specifying the link speed, but that had no noticeable effect. This is a
> LinkSys EtherFast under Red Hat 5.2. LinkSys claims this board works
> with Linux.
> 
> Please help.
> 
> -Dave
Until you ifconfig the device, netstat -i will NOT show it.

-- 
Jay Thorne  The Net Result System Services jay@result.com   
Http://net.result.com
Zoom 505 Effect page http://net.result.com/~jay 
Zoom 5xx series Patch Database: http://net.result.com/~jay/db.html