Vortex on PPC

[Rob Hagopian]

Hey there, I'm using the driver in 2.1.120 (0.99F) on a PowerPC and it
almost works :-) Running the driver in debug=6 gives this in syslog:

The PCI BIOS has not enabled this device!  Updating PCI command 0000->0005.
eth0: 3Com 3c905 Boomerang 100baseTx at 0x1c00, 00:60:97:9c:cf:d1, IRQ 30
  Internal config register is 16302d8, transceivers 0xe040.
  8K byte-wide RAM 5:3 Rx:Tx split, autoselect/undefined interface.
  Enabling bus-master transmits and whole-frame receives.
eth0: Initial media type MII.
eth0: MII #0 status ffff, link partner capability ffff, setting half-duplex.
eth0: vortex_open() InternalConfig 016306d8.
eth0: vortex_open() irq 30 media status 8802.
eth0:  Filling in the Rx ring.
eth0: Media selection timer tick happened, MII.
eth0: Media selection timer finished, MII.
eth0: Trying to send a packet, Tx index 0.
eth0: interrupt, status e201, latency 2 ticks.
eth0: In interrupt loop, status e201.
eth0: exiting interrupt, status e000.
eth0: Trying to send a packet, Tx index 1.
eth0: interrupt, status e201, latency 2 ticks.
eth0: In interrupt loop, status e201.
eth0: exiting interrupt, status e000.
...
eth0: vortex_close() status e000, Tx status 00.
eth0: vortex close stats: rx_nocopy 0 rx_copy 0 tx_queued 21 Rx
pre-checksummed 0.

Pings out give nothing... any ideas? TIA!
								-Rob