[tulip] (no subject)

[Ben Greear]

This driver/card only started working for me after the 2.4.8 (or so) kernel.

Before then, there are various bugs with auto-negotiate and other
stuff...

Ben

azafar wrote:

> After configuring a DLINK DFE-570TX four port card using tulip driver version 
> 0.92pb with Red Hat 7.0 (Kernel 2.2.16-22), I get the following error shortly 
> after adding load to the NIC "Too much work during an interrupt, 
> csr5=0xf0630040". Error repeats about 10 times every time it appears.Problem 
> occurs at random intervals and appears to be related to network load. I 
> attempted the fix "mii-diag eth2 -G 0x8b240000" but did not see any change in 
> the error. Any ideas on the cause of this problem and how to resolve it would 
> be appreciated.....
> 
> _______________________________________________
> tulip mailing list, tulip@scyld.com
> To change to digest mode or unsubscribe visit
> http://www.scyld.com/mailman/listinfo/tulip
> 
> 


-- 
Ben Greear <greearb@candelatech.com>       <Ben_Greear AT excite.com>
President of Candela Technologies Inc      http://www.candelatech.com
ScryMUD:  http://scry.wanfear.com     http://scry.wanfear.com/~greear