[tulip] ZNYX 4 port ZX346Q

[A James Lewis]

Ah, that's useful... but the version in 2.4.4 doesn't seem to be
maintained by Donald Becker, although the ChangeLog does say it was
"Merged" from 92t...

The driver says :-

"version 0.9.14e" in it....

Can anyone suggest what this is and what the current situation WRT
changing the driver is is the versions are different.

On Wed, 13 Jun 2001, john wiebe wrote:

>  We had the same problems, You need to use the 92t version of the driver for the
> ZNYX cards, though I haven't tried it with the 2.4 kernel yet.
>
>
> A James Lewis wrote:
> >
> > Hi,
> >
> > I recently set up a pair of servers with ZNYX ZX346Q 4 port cards and have
> > had nothing but problems....  The performance is really poor which I think
> > is due to the card not doing full duplex correctly since it reports lots
> > of collisions.... (The cards use 21143PD chips)
> >
> > I've swapped them for some SUN QFE cards which perform really well, but in
> > both cases only 3 of the 4 ports work...
> >
> > I would have to assume that 1 port not working would be somthing to do
> > with resource allocation rather than the card drivers themselves since it
> > happens on BOTH drivers...
> >
> > It's running 2.4.4 at the moment, and any suggestions would be really
> > helpful.
> >
> > A. James Lewis (james@fsck.co.uk)
> > Open Source Specialists  http://www.entora.co.uk/
> > Tel: +44 (0)701 0723686  Fax: +44 (0)870 3214368
> >
> > _______________________________________________
> > tulip mailing list, tulip@scyld.com
> > To change to digest mode or unsubscribe visit
> > http://www.scyld.com/mailman/listinfo/tulip

A. James Lewis (james@fsck.co.uk)
Open Source Specialists  http://www.entora.co.uk/
Tel: +44 (0)701 0723686  Fax: +44 (0)870 3214368