[tulip] - Newbie - Problems with installing the tulip.o modul

[David Kramer]

Thanks for the tip!

I ran depmod -a, then modprobe tulip.o, checked it with lsmod found that
pci-scan was used by tulip but tulip is still unused.  I then ran the dmesg
| grep eth0 command and it returned the following:

eth0: Lite-On PNIC-II rev 37 at 0xc88bc00, 00:A0:CC:32:99:C2, IRQ 11.

I must be missing a step here.....

Dave

-----Original Message-----
From: Donald Becker [mailto:becker@scyld.com]
Sent: Friday, September 08, 2000 10:02 AM
To: David Kramer
Cc: 'tulip@scyld.com'
Subject: RE: [tulip] - Newbie - Problems with installing the tulip.o
modul


On Fri, 8 Sep 2000, David Kramer wrote:

> When I ran the dmesg | grep eth0 command it returned the command line and
> nothing else.  I am completely running out of ideas here.  I do know that
> the card worked  before when I was running windows 95/98.  Is it possible
> that Im missing a step or something?

You must try to load the driver before looking for the messages.

Run 'dmesg | more'

> >       Vendor id=11ad. Device id=c115.
> This looks normal.  It's a LiteOn PNIC-II


Donald Becker				becker@scyld.com
Scyld Computing Corporation		http://www.scyld.com
410 Severn Ave. Suite 210		Beowulf-II Cluster Distribution
Annapolis MD 21403