[tulip] - Newbie - Problems with installing the tulip.o modul

[David Kramer]

Donald,

When I ran the dmesg | grep eth0 command it returned the command line and
nothing else.  I am completely running out of ideas here.  I do know that
the card worked  before when I was running windows 95/98.  Is it possible
that Im missing a step or something?

Thanks,

David

-----Original Message-----
From: Donald Becker [mailto:becker@scyld.com]
Sent: Thursday, September 07, 2000 8:16 PM
To: David Kramer
Cc: 'tulip@scyld.com'
Subject: RE: [tulip] - Newbie - Problems with installing the tulip.o
modul


On Thu, 7 Sep 2000, David Kramer wrote:

> I followed the instructions for setting my BIOS up correctly according to
> the IRQ-Conflict white paper (set OS Type = Other, and turned PnP off).
> Unfortunately I am still receiving errors. Also, I am using an HP 8160 PII
> 233. No clue what to try next. I ran the following commands and received
the
> following messages back:
> 
> COMMAND: dmesg | eth0
> RETURNED:
> bash: eth0: command not found

You probably wanted
 dmesg | grep eth0

The detection message is important.

>     Ethernet controller: LiteOn Unknown device (rev 37).
>       Vendor id=11ad. Device id=c115.
>       Medium devsel.  Fast back-to-back capable.  IRQ 11.  Master Capable.
> Latency=66.  Min Gnt=8.Max Lat=56.
>       I/O at 0xf400 [0xf401].
>       Non-prefetchable 32 bit memory at 0xfedfec00 [0xfedfec00].

This looks normal.  It's a LiteOn PNIC-II


Donald Becker				becker@scyld.com
Scyld Computing Corporation		http://www.scyld.com
410 Severn Ave. Suite 210		Beowulf-II Cluster Distribution
Annapolis MD 21403