[tulip] Tulip: PCI Fatal Bus Error

[KevinSCarr@aol.com]

I have been trying to set up a LinkSys Network Everywhere 10/100 Ethernet 
Card.  Model NC100 Version 2.0.

After building the Binary files, and installing them, I get the following 
error:

eth0:  PCI Fatal Bus Error, fc67e050


The following is what I get from an ifconfig command:

eth0      Link encap:Ethernet  HWaddr 00:00:78:02:F3:98  
          inet addr:192.161.21.1  Bcast:192.161.21.255  Mask:255.255.255.0
          UP BROADCAST RUNNING  MTU:1500  Metric:1
          RX packets:11 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100 
          Interrupt:10 Base address:0xec00 

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          UP LOOPBACK RUNNING  MTU:3924  Metric:1
          RX packets:42 errors:0 dropped:0 overruns:0 frame:0
          TX packets:42 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 


Thanks for any help in advance.

Scott