NDC Macronix more info

[Jim & Toni Dibb]

HMMM, just saw on another message as I was getting ready to send this there
is a 91g from 7/16.  Better get that downloaded.


Thanks to those who have replied so far it's given me some hope.

More info:
I said in my original message the link light on the hub never lights.
Checking it again tonight, both link lights (hub and card) come on at the
same time, and they both go out after the driver loads.

Under Win98 on both of my machines, the cards and hub work perfectly, lights
and all.

Here is some output from various commands that maybe someone might be able
to give me a little more help with.  I'm using "tulip.c:v0.91 4/14/99"

Thanks.



[root@polar /root]# ifconfig
lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Bcast:127.255.255.255  Mask:255.0.0.0
          UP BROADCAST LOOPBACK RUNNING  MTU:3584  Metric:1
          RX packets:18 errors:0 dropped:0 overruns:0
          TX packets:18 errors:0 dropped:0 overruns:0

eth0      Link encap:Ethernet  HWaddr 00:80:C6:F7:4C:73
          inet addr:192.168.0.1  Bcast:192.168.0.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0
          TX packets:0 errors:0 dropped:0 overruns:0
          Interrupt:9 Base address:0xfc00


[root@polar /root]# ./tulip-diag -p 0xfc00 -t 7
tulip-diag.c:v1.10 4/12/99 Donald Becker (becker@cesdis.gsfc.nasa.gov)
 Port selection is 10mpbs-serial 100baseTx scrambler, half-duplex.
 Transmit started, Receive started, half-duplex.
  The Rx process state is 'Waiting for packets'.
  The Tx process state is 'Idle'.
  The transmit threshold is 72.
 Use '-a' to show device registers,
     '-e' to show EEPROM contents,
  or '-m' to show MII management registers.
[root@polar /root]#
[root@polar /root]# cat /proc/pci
PCI devices found:
  Bus  0, device  14, function  0:
    VGA compatible controller: ATI 210888GX (rev 1).
      Medium devsel.  IRQ 9.
      Non-prefetchable 32 bit memory at 0xff000000.
  Bus  0, device   6, function  0:
    Ethernet controller: Unknown vendor MX98713 (rev 17).
      Medium devsel.  Fast back-to-back capable.  IRQ 9.  Master Capable.
Latency=66.  Min Gnt=8.Max Lat=56.
      I/O at 0xfc00.
      Non-prefetchable 32 bit memory at 0xfffbfc00.
  Bus  0, device   2, function  0:
    Non-VGA device: Intel 82378IB (rev 3).
      Medium devsel.  Master Capable.  No bursts.
  Bus  0, device   1, function  0:
    IDE interface: PCTECH RZ1000 (buggy) (rev 1).
      Fast devsel.
      I/O at 0x1f0.
      I/O at 0x3f4.
  Bus  0, device   0, function  0:
    Host bridge: Intel 82434LX Mercury/Neptune (rev 17).
      Slow devsel.  Master Capable.  Latency=64.
[root@polar /root]#