Compex RL100-TX, ABit BP6 SMP -> problem

[Travis Johnson]

Did you compile the tulip.c with the SMP compile command when you
switched to the SMP kernel?

"gcc -D__SMP__ -DMODULE -D__KERNEL__ -Wall -Wstrict-prototypes -O6 -c
tulip.c `[ -f /usr/include/linux/modversions.h ] && echo -DMODVERSIONS`"

Travis

Bas Rijniersce wrote:
> 
> Hi,
> 
> I thought I had send this message already, but I can find it in my
> outbox and not in my inbox, so I guess I have been dreaming. Sorry if it
> is the second copy :)
> 
> I installed an Abit BP 6 with dual Celeron chips today. In the bord I
> have a Compex RL100-TX 100 Mb NIC:
> eth0: Digital DS21143 Tulip rev 65 at 0xa400, 00:80:48:CD:53:8B, IRQ 9.
> 
> This bord and NIC is running Linux 2.2.11 compiled without SMP OK. But
> if I compile it as SMP I get get:
> tulip.c:v0.91g 7/16/99 becker@cesdis.gsfc.nasa.gov
> eth0: Digital DS21143 Tulip rev 65 at 0xa400, 00:80:48:CD:53:8B, IRQ 9.
> eth0:  EEPROM default media type Autosense.
> eth0:  Index #0 - Media MII (#11) described by a 21142 MII PHY (3)
> block.
> eth0:  MII transceiver #8 config 3000 status 782d advertising 01e1.
> eth0: Tx hung, 7 vs. 0.
> eth0: Tx hung, 15 vs. 0.
> 
> I tried both the tulip.c that comes with 2.2.1 (0.83H), 0.91e and 0.91g.
> All the same problem, I also tried to use tulip as a module without
> succes.
> 
> Any suggestions?
> 
> Tia,
> Bas
> 
> ----
> Bas Rijniersce                       Phone +31 341 550545
> Oude Telgterweg 81                   Fax +31 341 562940
> 3851 EA  Ermelo                      http://www.brijn.nu
> The Netherlands                      bas@brijn.nu