[eepro100] eepro100 woes
Mon, 02 Oct 2000 22:19:43 -0600
Thanks for the speedy reply!
I'm only setting the debug level to 6, not passing anything else (except
i did try the append "noapic" trick to lilo.conf but that didn't change
I've since managed to get an ISA 3c509 to work just fine on the machine
but i'd love to assist in further debugging the problem with this card
(if you're still interested in doing so).
Donald Becker wrote:
> On Mon, 2 Oct 2000, arthur dent wrote:
> > [root@bessie local]# ./pci-config -#4
> > pci-config.c:v2.01 7/4/2000 Donald Becker (email@example.com)
> > http://www.scyld.com/diag/index.html
> > Device #4 at bus 0 device/function 12/0.
> > Power management entry ver. 2: Capabilities 7e22, Ctrl 4000, Event
> > 3a00.
> > Power state D0.
> > ^^^^^^^^^^^^^^^^^^from the previous posts on the list i take it this is
> > bad. I need a D1, D2 or D3 right?
> No. D1, D2 and D3 are increasingly powered-down states. The adapter is
> mostly off in D3 state, with at most only Wake-On-LAN circuitry powered up.
> > [root@bessie local]# ./mii-diag
> > Using the default interface 'eth0'.
> > Basic registers of MII PHY #1: 1000 7809 02a8 0154 0001 0021 0000 0000.
> > Basic mode control register 0x1000: Auto-negotiation enabled.
> > Basic mode status register 0x7809 ... 7809.
> > Link status: not established.
> > Your link partner is generating 10baseT link beat (no
> > autonegotiation).
> This is very curious: you are advertising no capabilities!
> Are you passing in any module options?
> I'll check out the option settings to see what might be going wrong...
> Donald Becker firstname.lastname@example.org
> Scyld Computing Corporation http://www.scyld.com
> 410 Severn Ave. Suite 210 Generation Two Beowulf Clusters
> Annapolis MD 21403
> eepro100 mailing list