[eepro100] New problem with eepro100 and StrongArm board

[David =?iso-8859-1?Q?M=FCller?= (ELSOFT AG)]

Hi again

After the upgrade to Linux 2.4.0-test2, the self test of the Intel 82559
based NIC (on a StrongArm eval board) seems to work quite good, but now i 
have a new problem.

eepro100.c:v1.09j-t 9/29/99 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/eepro100.html
eepro100.c: $Revision: 1.33 $ 2000/05/24 Modified by Andrey V. Savochkin <saw@saw.sw.com.sg> and others
Found Intel i82557 PCI Speedo, MMIO at 0x4080000, IRQ 22.
eth0: Intel Corporation 82557 [Ethernet Pro 100], 00:D0:B7:4C:36:56, IRQ 22.
  Receiver lock-up bug exists -- enabling work-around.
  Board assembly 721383-008, Physical connectors present: RJ45
  Primary interface chip i82555 PHY #1.
  General self-test: passed.
  Serial sub-system self-test: passed.
  Internal registers self-test: passed.
  ROM checksum self-test: passed (0x04f4518b).
Sending BOOTP requests....<7>eth0: Link status change.
.<7>eth0: Media control tick, status e050.
.<7>eth0: Media control tick, status e050.
.<7>eth0: Media control tick, status e050.
.<7>eth0: Media control tick, status e050.
.<7>eth0: Media control tick, status e050.
.<7>eth0: Media control tick, status f048.
.<7>eth0: Media control tick, status f048.
.<7>eth0: Media control tick, status f048.
.<7>eth0: Media control tick, status f048.
 timed out!
IP-Config: Auto-configuration of network failed.

My BOOTP server gets the request and responses to it, but the
reply seems to get lost.
As the FR bit in the status register is set, i think that the 
reply packet was received, but not further processed.


TIA

Dave