[eepro100] Need Serious Help w/ eepro100 Driver/card
Wed, 27 Dec 2000 03:09:02 -0500
Thanks for the response Alvin. I was about to pull my hair out. So
I assume from the eepro100.c file on your site that I can compile
this one and it runs without the pci-scan.o? Also, is it already
patched or do I need to patch it? Forgive my ignorance but how do I
patch it if I need to. No need for X11.
I see from the discussions pointed to on your site the need for a
patch. The last question, will this work with kernet 2.2.14 or will
I have to compile 2.2.16 ?
Thanks again for your help!
---- Original Message ----
Subject: Re: [eepro100] Need Serious Help w/ eepro100 Driver/card
Date: Tue, 26 Dec 2000 23:12:43 -0800 (PST)
>hi ya infinity...
>to to the intelwebsite or look at my stuff...
>- depending on the kernel...you might need topatch the eepro100.c
> - look at the eepro* stuff
>you will probably need X11 help too???
>but.. d816eeaal w/ rh6.2 works fine...just need to tweek it
>On Wed, 27 Dec 2000, Infinity2 wrote:
>> I have just built a new Hosting server. It has an Intel D815EAL
>> Integrated LAN. No matter what I do, I cannot get it to load the
>> for the eepro100 at startup. It always says "Delaying eth0
>> This is RH V6.2. If I go into /lib/modules/2.2.14-5.0/net and run:
>> linux4# insmod pci-scan.o and
>> linux4# insmod eepro100.o
>> it will load the modules
>> then if I try to ifup eth0 it works "sometimes"
>> and sometimes it just freezes.
>> I checked the module.dep and it lists pci-scan.o as a dependency
>> What am I missing? Where do I start. I have tried everything I
>can find on
>> the subject.
>> BTW. The eepro100 and pci-scan were versions downloaded from
>> and compiled on the server. Help?
>> Thanks in advance,
>> Rob Spurlock
>> Lock-Net Internet Services
>> Get Locked On! With Lock-Net!
>> eepro100 mailing list