[vortex-bug] 3c575_cb-help

[franzi]

Hi to evryone ,hoping to get some help to resolving
this ungusting problem about my pcmcia 3ccfe575bt.
I've downloded the last version of pcmcia ,but problems accours always.
laptop ACER extensa 390 with 64 MB ram .
I put the last version pcmcia in /usr/src/kernel-source-2.4.18-bf2.4
Debian distribution"woody",done make config requested the things,it
seemed avrything ok rebooted
card done just 1 beep and the green light on the 10MB .
doing /lib/modules/2.4etc/pcmcia# modprobe 3c575_cb
3c59x.c:v0.99q 5/16/2000
doing /etc/init.d/pcmcia restart in second time 
shutting down PCMCIA services:cardmgr modules Device or resources busy
i82365 :devices busy
cardmgr[643] watching 2 sockets
cardmgr[643] could not adjust resources:IO ports 0x200-0x27f:Devices or
resources busy.
So i must reboot and the pcmcia network card is still on the 10MB ligth
redoing the samething that i described over
it gives me
shutting down PCMCIA services:cardmgr modules Device or
resources busy
i82365 :devices busy
.
Starting Pcmcia services:cardmgr
cardmgr[510]:watching 2 sockets
cardmgr[510]:could not adjust resources:IO ports 0x200-0x27f: Devices or
resources busy
debian:/lib/modules/ 2.4.18-bf2.4/pcmcia#cb_config(bus 5)
cs: IO ports probe 0x0100-0x04ff:excluding 0x3c0-0x3df
cs: IO ports probe 0x03e0-0x04ff:clean
cs: IO ports probe 0x0800-0x08ff:clean
cs: IO ports probe 0x0a00-0x0aff:clean
cs: IO ports probe 0x0c00-0x0cff:clean
cs: IO ports probe 0x1000-0x17ff:clean
  fn 0 bar 1: io 0x280-0x2ff
  fn 0 bar 2: mem 0x60021000-0x6002107f
  fn 0 bar 3: mem 0x60020000-0x6002007f
  fn 0 rom: mem 0x60000000-0x6001ffff
  irq5
vortex_attach(device 05:00.0)
eth0:3com 3CCFE575BT Cyclòon cardbus at 0x280, 00:10:4b:f5:b9:b1,irq5
 product code 'NV' rev 07.1 date 10-28-98
 8K byte-wide RAM 5:3 Rx:Tx split, MII interface
 eth0:transmit timed out,tx_status 00 status e000.
 diagnostic: net 0cc2 media a800 dma 000000a0
 
Now the light card is on 100MB but can't ping to anywhere why?
restarting the card the light is on 10MB
doing dmseg | tail
PnP: PnP BIOS installation structure at 0xc00f53e0
PnP: PnP BIOS version 1.0 entry at f9f00:0,dseg at f0000
intel ISA/PCI/CARDBUS PCIC probe
PCI:GUessed IRQ 9 for devices 00:05.0
PCI:GUessed IRQ 9 for devices 00:05.1
 TI 1250A rev 02 PCI-to-CARDBUS at slot 00:05,mem 0x10000000
 host opts [0]:[ring] [isa irq] [pci irq 9] [lat 32/176] [bus 1/4]
 host opts [1]:[ring] [isa irq] [pci irq 9] [lat 32/176] [bus 5/8]
PCI irq 9 test failed
ISA irqs (scanned) =3,5,10,11 satus change on irq 11
 cardmgr.
cardmgr[677]:watching 2 sockets
cardmgr[677]: could not adjust resources:IO ports 0x200-0x27f:Device or
resources busy
debian:/lim/modules/2.4.18-bf2.4/pcmcia#cs: cb_alloc(bus 5): vendor
0x10b7,device 0x0000
 That's all folks
Is there anyone who can helpme??
Thanks in advanced