3CCFE575CT tx problem

[pedracini@libero.it]

I have some problems with my 3com 3CCFE575CT pcmcia card in linux. At 
 the end of system startup I must do a "network restart" to be able to 
 use network. However, the big problem is that sometimes the eth0 stops 
 working and gives these error messages:
 
 eth0: transmit timed out, tx_status 00 status e000
 eth0: transmit timed out, tx_status 00 status e000
 Tx ring full refusing to send buffer
 
 After that there is no way to tranfer data on the lan anymore. Sometimes 
 the solution is to restart the network service, but sometimes I must 
 reboot the system.
 Have you any suggestion to solve this problem?
 
 thanks a lot,
 
 Fabrizio Pedracini
 
 System
 Mandrake 7.0 - Kernel 2.2.15-0.16mdk pcmcia-3.1.11
 
 These are the messages related with Pcmcia Cardbus during the boot 
 sequence:
 cardmgr[141]: starting, version is 3.1.11
 cardmgr[141]: initializing socket 0 
 cardmgr[141]:executing: 
 'insmod/lib/modules/2.2.15-0.16mdk/pcmcia/cb_enabler.0'
 cardmgr[141]: executing: './network start eth0'
 version is 3.1.11 Intel PCIC probe:
 TI 1225 PCI-to-CardBus at slot 00:04, mem 0x41100000
 host opts [0]: [ring] [pci + serial irq] [no pci irq] [lat 66/176]        
 [bus 2/2] 
 host opts [1]: [ring] [pci + serial irq] [no pci irq] [lat 66/176]
 [bus 3/3]
 ISA irqs (scanned) = 9,15 polling interval = 1000ms
 cs: IO port probe 0x0c00-0x0cff: clean 
 cs: IO port probe 0x0800-0x08ff: clean
 cs: IO port probe 0x0100-0x04ff: clean
 cs: IO port probe 0x0a00-0x0aff: clean
 cs: cb_alloc(bus 2): vendor 0x10b7, device 0x5257 
 3c59x.c:v0.99L 5/28/99 Donald Becker 
 http://cesdis.gsfc.nasa.gov/linux/drivers/vortex.html
 cs: cb_config(bus 2)
 fn 0 bar 1: io 0x200-0x27f
 fn 0 bar 2: io 0x60020000-0x6002107f	
 fn 0 bar 3: mem 0x60020000 0x6002007f
 fn 0 rom: mem 0x60000000-0x6001ffff
 vortex_attach(bus 2, function 0, device 5257)
 3CCFE575CT Cyclone Cardbus at 0x200, Mac-address, IRQ 9
 Cardbus function mapped 60020000->c804b000
 8K bite-wide RAM 5:3 Rx:Tx split, MII interface
 MII tranceiver found at address 0, status 7809
 Enabli

 
 
 
 
 
-------------------------------------------------------------------
To unsubscribe send a message body containing "unsubscribe"
to linux-vortex-bug-request@beowulf.org