almost got it...

[Brian Lewis]

Everyone,

  Thank you for your replies to my problem.  I have progressed further!!!
  
   I have compiled the latest 3c59x.c into a .o and replace the original file.
   On bootup, ETH0 is initialized properly!
   If I type IFCONFIG it displays the ETH0 CARD!!!
   When I PING the Interface for that card it works!!!

BUT!

   1) If I look at the back of the card or the 10/100Mbps hubs, I notice the unit is in
   10Mbps mode instead of 100Mbps.

   2) I can't ping anything other than the ip of the card!  I can't ping the default Gateway/server
   NIC is 192.168.0.99/24 and the server I am trying to ping is 192.168.0.100 !!
   Route -V shows all routing tables are properly configured!  

   So what I think is that something is still not initialized properly since any pings
   outside to the FLAT network don't come back.  They work fine on the same machine
   in W2000 RC1 so I know its not the hardware.

Anyone have any ideas on what to change to get it to 100Mbps, I believe that might fix
my problem..