[tulip] overruns ?

[James Stevenson]

> On Thu, 17 Jan 2002, James Stevenson wrote:
>
> > > On Thu, 17 Jan 2002, James Stevenson wrote:
> > >
> > > > > On Wed, 16 Jan 2002, James Stevenson wrote:
> > > > > > i have 2 cards from SMC each in 2 different computers and a
100mbps
> > > > switch
> > > > > > both work fine well almost in Full Duplex 100mbps.
> > > > >
> > > > > What is the detection message?
> > >
> > > What is the detection message?
>
> > Using the default interface 'eth0'.
> > Basic registers of MII PHY #1:  3000 786d 0022 5410 01e1 45e1 0005 2801.
>
> What is the detection message?
> The driver detection message, including the version number and
> information about the chip and supported media types.

>From /proc/pci under 2.4.17

Ethernet controller: Accton Technology Corporation EN-1216 Ethernet Adapter
(rev 17).
IRQ 10.
Master Capable.  Latency=64.  Min Gnt=255.Max Lat=255.
I/O at 0xe400 [0xe4ff].

>From ls pci
00:09.0 Ethernet controller: Accton Technology Corporation: Unknown device
1216 (rev 11)
00:09.0 Class 0200: 1113:1216 (rev 11)

>From dmesg
Linux Tulip driver version 0.9.15-pre9 (Nov 6, 2001)
PCI: Found IRQ 10 for device 00:09.0
eth0: ADMtek Comet rev 17 at 0xe400, 00:04:E2:1E:FE:B3, IRQ 10.

>From the box :)
SMC 1255TX

if i new where tio get the doc's for the card i would have a go
and debugging it myself.

> In this case the driver version and specific chip in use is important.
>
> >  The autonegotiated capability is 01e0.
> > The autonegotiated media type is 100baseTx-FD.
> >  Basic mode control register 0x3000: Auto-negotiation enabled.
> >  You have link beat, and everything is working OK.
> >  Your link partner advertised 45e1: Flow-control 100baseTx-FD 100baseTx
> > 10baseT-FD 10baseT, w/ 802.3X flow control.
> >    End of basic transceiver information.