[tulip] PCMPC200 v2 gives Unresolved Symbols on 2.4.7-10

[Jason A. Pfeil]

Donald,

Thank you so much for this!  I made the new tulip.o driver and it worked 
purrfectly!  I discovered that my previous unresolved symbols 
(pci_drv_register and pci_drv_unregister) were because I hadn't been 
inserting the pci_shim.o module.  With that and then the tulip.o, by 
Linksys CardBus card is very happie!

Thank you, thank you, thank you!

--Jason

On Wed, 28 Aug 2002, Donald Becker wrote:

> On Wed, 28 Aug 2002, Jason A. Pfeil wrote:
> > On Sun, 25 Aug 2002, Donald Becker wrote:
> > [...snip...]
> > > > 
> > > > tulip.o: init_module: No such device
> > > The driver didn't find a recognized card.
> > Here is the information provided by cat /proc/pci for the netcard:
> >     Ethernet controller: PCI device 1737:ab09 (rev 17).
> 
> OK, this ID was only added recently:
> ________________
> tulip.c:v0.95b 8/2/2002
> 
> Added PCI table entries
>   1737 ab09  Linksys PCM200 v3 CardBus, ADMtek Centaur-C
>   1113 1216  SMC1255TX, ADMtek Comet
> ----------------------------
> 
> [[ typing noise in the background ]]
> 
> I just put out a new version of netdrivers.tgz that includes 0.95b:
> 
> mkdir /tmp/netdrivers/
> cd /tmp/netdrivers/
> ncftp ftp://ftp.scyld.com/pub/network/netdrivers.tgz
> tar xfvz netdrivers.tgz
> make
> make install
> 
> 
> 
> 

-- 
Jason A. Pfeil                           13700 Richmond Park Dr. N. #1104
                                         Jacksonville, FL  32224
                                         jason.pfeil@jasonpfeil.com