[tulip] Unresolved symbols w. 2.4.7
Mon Aug 19 12:55:01 2002
Recently, I have downloaded the netdrivers.tgz package on my Mandrake 8.2 linux box (2.4.18 kernel)
The 'make' step was successfull. But the 'make install' was not!
The goal of all this is to make my DLink DFE 570TX 4 NICs working (tulip 21143 chip).
When I have run the 'make install' step, here is the screen output :
Makefile:46: No kernel version has been specified.
Set the KERNVER variable to specify a different kernel."
mkdir -p /lib/modules/2.4.18-6mdk/kernel/drivers//net/
install -m 444 pci-scan.o 3c59x.o eepro100.o epic100.o hamachi.o intel-gige.o myson803.o natsemi.o ns820.o
rtl8139.o starfire.o sundance.o tulip.o via-rhine.o winbond-840.o yellowfin.o
depmod: *** Unresolved symbols in /lib/modules/2.4.18-6mdk/kernel/drivers/pcmcia/cb_shim.o
make: *** [install] Error 1
What should I do to solve this problem ?
What to do afterwards to configure my four NICs of this card ?
Thanks very much for your help.
On Fri, 16 Aug 2002 email@example.com wrote:
> I'm trying to get my Conexant NIC to work on a Compaq Presario 17xl365
> laptop. Other users of the same laptop have reported success in getting
> the card to work with the tulip driver. I'm using Red Hat 7.2 with
> 2.4.7. Both pci-scan.c and tulip.c compiles, but when doing "insmod" I
> get a lot of messages about "unresolved symbol".
Try downloading and compiling the driver with
tar xfvz netdrivers.tgz
I'm temporarily recommending this approach instead of the binary or
source RPM. Red Hat has several different kernels that are distributed
as being "7.2", and each requires different module versions.
Donald Becker firstname.lastname@example.org
Scyld Computing Corporation http://www.scyld.com
410 Severn Ave. Suite 210 Second Generation Beowulf Clusters
Annapolis MD 21403 410-990-9993
tulip mailing list, email@example.com To change to digest mode or unsubscribe visit
21/29, rue Chevreul
TÚl : +33 2 41 18 28 28