[tulip] Can't get Accton EN1207 to work in 100MBit

[Marcus Blomenkamp]

Am Mittwoch, 12. September 2001 16:30 schrieb Donald Becker:
> Did you do a google search?

Yepp, lots of results pointing to this mailing list. groups.google.com also 
showed mainly problems not solutions :-(. I thought, perhaps someone recalled 
a very simple solution or nogo-situation.

> What driver version are you trying to use?
> What is the detection message?
>

Oh, I forgot.

Kernels 2.4.7 + 2.4.9

dmesg shows (after loading with options=4):

Linux Tulip driver version 0.9.15-pre6 (July 2, 2001)
PCI: Found IRQ 12 for device 00:0d.0
tulip0: Transceiver selection forced to 10baseT-FDX.
tulip0: Old format EEPROM on 'Accton EN1207' board.  Using substitute
media control info.
tulip0:  EEPROM default media type Autosense.
tulip0:  Index #0 - Media 10base2 (#1) described by a 21140 non-MII (0) block.
tulip0:  Index #1 - Media 10baseT (#0) described by a 21140 non-MII (0) block.
tulip0:  Index #2 - Media 10baseT-FDX (#4) described by a 21140 non-MII (0) 
block.
tulip0:  Index #3 - Media 100baseTx (#3) described by a 21140 non-MII
(0) block.
tulip0:  Index #4 - Media 100baseTx-FDX (#5) described by a 21140 non-MII (0) 
block.
eth0: Digital DS21140 Tulip rev 17 at 0xe800, 00:00:E8:15:DA:BA, IRQ 12.
eth0: Using user-specified media 10baseT-FDX.

cu Marcus