[tulip] delaying eth1... newbie help

[Donald Becker]

On Fri, 7 Sep 2001, iS wrote:

> RE: Linksys Fast Ethernet v.4 (Lite-on chip) on RH6.1
> (2.2.12-20)
> 
> After downloading, compiling and installing the latest
> tulip, I get "delaying eth1 init... [FAILED]"

What is the detection message?  (Run 'dmesg' to see...)

> I'm using a manual ip setup for now although
> eventually I'd like to use this card as a 10baseT half
> duplex cable modem (dhcp) card.

That implies that the driver is working.  If so, you have an IP address
configuration problem, or perhaps its as simple as not providing the
correct module name in /etc/modules.conf.

Donald Becker				becker@scyld.com
Scyld Computing Corporation		http://www.scyld.com
410 Severn Ave. Suite 210		Second Generation Beowulf Clusters
Annapolis MD 21403			410-990-9993