Digital Tulip Design

[Homer Wilson Smith]

    HI Donald, thanks for your work, this is good news.

    I was not able to get v92g to run in linux 2.0.36.

    Homer
    
superoot jane/usr/local/main/tulip: insmod tulip.o
pci_drv_register: wrong version or undefined
pci_drv_unregister: wrong version or undefined
Loading failed! The module symbols (from linux-2.0.36) don't match your linux-2.0.36

------------------------------------------------------------------------
Homer Wilson Smith   Clear Air, Clear Water,  Art Matrix - Lightlink
(607) 277-0959       A Green Earth and Peace. Internet Access, Ithaca NY
homer@lightlink.com  Is that too much to ask? http://www.lightlink.com

On Sun, 7 May 2000, Donald Becker wrote:

> On Sat, 6 May 2000, Homer Wilson Smith wrote:
> 
> > > >    Do we have a driver yet that will do 10 meg full duplex on these
> > > > babies?  
> > > 
> > > Yes, both the 91g and 92 versions should work fine.
> > 
> >      I have not been able to get either to work.
> > 
> >      Linux 2.0.36  Kingston KNE100TX 21143
> 
> I just tested the following configuration
>    tulip.c v92, as distributed.
>    a Kingston KNE100TX
>       21143-PD
>       Seeq 80220 MII transceiver
>      [[ This board has a label "Do not remove this sample from engineering
>         lab";->  I guess someone at Kingston is now in trouble.. ]] 
>    on a BP-6
>      Celeron
>      440BX chipset
> 
> It works fine with all media types, both autonegotiated and forced.
> 
> ________________
> tulip.c:v0.92 4/17/2000  Written by Donald Becker <becker@scyld.com>
>   http://www.scyld.com/network/tulip.html
> ...
> eth1: Digital DS21143 Tulip rev 65 at 0x88021000, 00:C0:F0:3B:00:02, IRQ 10.
> eth1:  EEPROM default media type Autosense.
> eth1:  Index #0 - Media MII (#11) described by a 21142 MII PHY (3) block.
> eth1:  MII transceiver #1 config 3000 status 7809 advertising 01e1.
> ...
> eth1: Setting full-duplex based on MII #1 link partner capability of 41e1.
> eth1: Setting half-duplex based on MII #1 link partner capability of 4021.
> 
> [[ Other messages omitted. ]]
> ________________
> 
> I claim that you have some other problem.
> 
> [[ Grrrr.  This took me 30 minutes to do, due to the damn APIC bugs.  I
> finally gave up and just booted with "noapic". ]]
> 
> Donald Becker				becker@scyld.com
> Scyld Computing Corporation
> 410 Severn Ave. Suite 210
> Annapolis MD 21403
> 
> 


-------------------------------------------------------------------
To unsubscribe send a message body containing "unsubscribe"
to linux-tulip-request@beowulf.org