Adaptec ANA6922-A

[W.Schlich]

Hello!

I got an Adaptec ANA6922-A Ethercard and am now looking
for drivers. On http://cesdis.gsfc.nasa.gov/linux/drivers/ethercard.html
is written:
"The Adaptect DuraLAN (AKA "Starfire") chip, starfire.c. The DuraLAN
chip is used on the new 64 bit PCI boards from Adaptec e.g. the
ANA-6922A. The older 32 bit boards use the tulip driver."
The ANA6922-A is a 32 bit board! But when using the Tulip-Driver
I get the following error:
-------------
Mar 28 15:18:56 ukq-kkat kernel: tulip.c:v0.89H 5/23/98
becker@cesdis.gsfc.nasa.gov
Mar 28 15:18:56 ukq-kkat kernel: eth0: Digital DS21142/3 Tulip at 0x9c00, 00
00 d1 10 96 a7, IRQ 9.
Mar 28 15:18:56 ukq-kkat kernel: eth0:  EEPROM default media type Autosense.
Mar 28 15:18:56 ukq-kkat kernel: eth0:  Index #0 - Media MII (#11) described
by a 21142 MII PHY (3) block.
Mar 28 15:18:56 ukq-kkat kernel: eth0: ***WARNING***: No MII transceiver
found!
Mar 28 15:18:56 ukq-kkat kernel: eth1: Digital DS21142/3 Tulip at 0x9800,
EEPROM not present, 00 00 d1 10 96 a8, IRQ 9.
Mar 28 15:18:56 ukq-kkat kernel: eth1:  Controller 1 of multiport board.
Mar 28 15:18:56 ukq-kkat kernel: eth1:  EEPROM default media type Autosense.
Mar 28 15:18:56 ukq-kkat kernel: eth1:  Index #0 - Media MII (#11) described
by a 21142 MII PHY (3) block.
Mar 28 15:18:56 ukq-kkat kernel: eth1: ***WARNING***: No MII transceiver
found!
-------------
What am I doing wrong?!

Thanx in advance for your help.

Regards

|  Wolfram Schlich
------------------------------------------------------------------
|  w3-connexions
|  WebDesign, Software, Hardware
|  E-Mail: ws@w3-connexions.de
|  Internet: http://www.w3-connexions.de
|  Tel.: +49-(0)2636-941194 / Fax: -941193
|  ICQ #: 35713642






-------------------------------------------------------------------
To unsubscribe send a message body containing "unsubscribe"
to linux-tulip-request@beowulf.org