[tulip] LinkSys LNE100TX (again)

[Chris Blown]

phoneranger wrote:

> >
> > no, that is the correct subnet mask. what about route. just paste the output
> > from the "route" command and "route -n". and paste the info from "ifconfig"
> > as well, this is all done on the linux box. then on the windows box run from
> > the start_menu->run "winipcfg" and that will popup a box on the screen, you
> > may have to change the device to the network card and the do show details.
> > And send that info aswell, the other could be faulty cables have you tried
> > other cables.
> >
>
> For the Linux box, obviously :)
> ----------------------
> Kernel IP routing table
> Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
> 192.168.1.1     *               255.255.255.255 UH    0      0        0 eth0
> 168.191.82.2    *               255.255.255.255 UH    0      0        0 ppp0
> 192.0.0.0       *               255.0.0.0       U     0      0        0 eth0
> 127.0.0.0       *               255.0.0.0       U     0      0        0 lo
> default         168.191.82.2    0.0.0.0         UG    0      0        0 ppp0
>
> Kernel IP routing table
> Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
> 192.168.1.1     0.0.0.0         255.255.255.255 UH    0      0        0 eth0
> 168.191.82.2    0.0.0.0         255.255.255.255 UH    0      0        0 ppp0
> 192.0.0.0       0.0.0.0         255.0.0.0       U     0      0        0 eth0
> 127.0.0.0       0.0.0.0         255.0.0.0       U     0      0        0 lo
> 0.0.0.0         168.191.82.2    0.0.0.0         UG    0      0        0 ppp0
>
> eth0      Link encap:Ethernet  HWaddr 00:A0:CC:E1:8B:C6
>           inet addr:192.168.1.1  Bcast:192.255.255.255  Mask:255.0.0.0
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:4 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:75 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:1 txqueuelen:100
>           Interrupt:19 Base address:0xf000
>
> lo        Link encap:Local Loopback
>           inet addr:127.0.0.1  Mask:255.0.0.0
>           UP LOOPBACK RUNNING  MTU:3924  Metric:1
>           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:0
>
> ppp0      Link encap:Point-to-Point Protocol
>           inet addr:168.191.91.30  P-t-P:168.191.82.2  Mask:255.255.255.255
>           UP POINTOPOINT RUNNING NOARP MULTICAST  MTU:1500  Metric:1
>           RX packets:73 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:55 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:10
>
> On the Win95 box:
> --------------
> LinkSys LNE100TX
> mac address: 00-A0-CC-E2-A8-7B
> ip address:  192.168.1.11
> subnet:  255.255.255.0
> default gateway:  162.168.1.1    (the linux box)
>
>

As Jason suggested, I would check your cable. As far as I can tell the
above looks ok, though your subnet mask could be changed back
to 255.255.255.0 .