PacBell is handing out these cards to new DSL customers, and I can't
get it to work with Linux 2.0.36. Any help would be appreciated. I
don't _need_ this card at the moment, but it would be nice to have it
working at some point.
Here is what the driver says when it starts up:
tulip.c:v0.90q 2/23/99 becker@cesdis.gsfc.nasa.gov
eth2: Lite-On 82c168 PNIC rev 32 at 0xf800, 00:C0:F0:2D:40:E5, IRQ 9.
eth2: MII transceiver #0 config 800f status 801f advertising 804f.
eth2: MII transceiver #1 config 820f status 821f advertising 824f.
eth2: MII transceiver #2 config 840f status 841f advertising 844f.
eth2: MII transceiver #3 config 860f status 861f advertising 864f.
eth2: Changing PNIC configuration to half-duplex, CSR6 810e0000.
/proc/pci sees the device:
Bus 0, device 14, function 0:
Ethernet controller: Unknown vendor LNE100TX (rev 32).
Medium devsel. Fast back-to-back capable. IRQ 9. Master Capable.
Latency=66.
I/O at 0xf800.
Non-prefetchable 32 bit memory at 0xffbfec00.
tulip-diag reports:
tulip-diag.c:v1.08 2/28/99 Donald Becker (becker@cesdis.gsfc.nasa.gov)
Digital Tulip, unknown type Tulip chip registers at 0xf800:
00008000 01ff0000 44444444 00fff820 00fffa20 02201100 810e0000 00000000
00000000 000040e5 00fffa30 00fffa30 0000002d 00000000 00000000 10000001
Port selection is MII, half-duplex.
Transmit stopped, Receive stopped, half-duplex.
The Rx process state is 'Stopped'.
The Tx process state is 'Waiting for Tx to finish'.
The transmit threshold is 128.
EEPROM contents:
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
0000 0000 0000 0000 0000 0000 0000 0000
ID CRC 0xe3 (vs. 00), complete CRC 3b59d4af.
* An old-style EEPROM layout was found.
* The old-style layout does not contain transceiver control information.
* This board may not work, or may work only with a subset of transceiver
* options or data rates.
***WARNING***: No MII transceivers found!
--
Steve Madsen <steve@moonglade.com>
PGP encrypted email preferred -- key on keyservers