tulip.c 0.91 on Alpha PC164UX/Linux 2.2.6

Albrecht Jacobs aj@klee.architektur.uni-stuttgart.de
Thu Apr 22 16:32:32 1999

On Thu, 22 Apr 1999, Greg Siekas wrote:

> Get tulip-diag and libmii.c and get the output from the diags. 
> Albrecht Jacobs wrote:
> > 
> > Hi all,
> > 
> > I am new to this list--hope not to ask the same old questions again ...
> > 
> > I am currently running Linux 2.2.6 on an Alpha PC164UX2.  I tried out
> > tulip.c 0.91 but it doesn't work :-( The port LEDs on the connected switch
> > blink unsteadily (they should burn steady, only flashing out when traffic
> > is detected).  At the moment 0.90q seems to work best with my hardware but
> > I have to use 'options=16,0' (there is a second interface on an
> > Intraserver adapter) to force it to 100 Mbit. Sometimes the connection
> > gets lost, sometimes its only half duplex.

Here is the output of tulip-diag. Note that eth1 (Index#2) isn't configured:

[root@lem 0.90q]# ./tulip-diag -a -f -m
tulip-diag.c:v1.08 2/28/99 Donald Becker (becker@cesdis.gsfc.nasa.gov)
Index #1: Found a Digital DS21143 Tulip adapter at 0x8000.
Digital DS21143 Tulip Tulip chip registers at 0x8000:
  ffa0e000 ffffffff ffffffff 4000d018 4000d218 f0660000 b3862202 fbfffbff
  e0000000 fff583ff ffffffff fffe0000 000000c4 ffff0000 fff80000 8ff4c008
 Port selection is 100mbps-SYM/PCS 100baseTx scrambler, full-duplex.
 Transmit started, Receive started, full-duplex.
  The Rx process state is 'Waiting for packets'.
  The Tx process state is 'Idle'.
  The transmit threshold is 128.
 ***WARNING***: No MII transceivers found!
  Internal autonegotiation state is 'Autonegotiation disabled'.
Index #2: Found a Digital DS21140 Tulip adapter at 0xa000.
Digital DS21140 Tulip Tulip chip registers at 0xa000:
  fe000000 ffffffff ffffffff ff8efebf feb68c7f fc000000 32000040 fffe0000
  e0000000 ffffcbf8 ffffffff fffe0000 ffffff00 ffffffff 1c09fdc0 fffffec8
 Port selection is 10mpbs-serial, half-duplex.
 Transmit stopped, Receive stopped, half-duplex.
  The Rx process state is 'Stopped'.
  The Tx process state is 'Stopped'.
  The transmit threshold is 72.
 MII PHY found at address 5, status 0x784b.
[root@lem 0.90q]#


| cand. aer. Albrecht Jacobs                            CAAD-Labor des SI |
| Systembetreuung                                  Universit"at Stuttgart |
|                                                                         |
| Liegeradgruppe Stuttgart                                                | 
|  O__       http://www.architektur.uni-stuttgart.de:1200/users/aj/lieger |
|  \\_/\-o                                                                |
| (+)   O               Albrecht.Jacobs@klee.architektur.uni-stuttgart.de |