[realtek] problem installing driver rtl8139

Panard panard@inzenet.org
Mon Dec 9 07:16:01 2002

Hi !

I've a big problem.
I've a kernel 2.4.19, and when I make 'insmod rtl8139.o', I've the error :
no surch device

But, when I make   ./rtl8139-diag -aem, I've the ouput :
rtl8139-diag.c:v2.10 9/18/2002 Donald Becker (becker@scyld.com)
Index #1: Found a RealTek RTL8139 adapter at 0xd000.
RealTek chip registers at 0xd000
 0x000: 96fc5000 00009033 b9f38105 0a00b18d 00002000 00002000 00002000 
 0x020: 00001000 00300028 20004000 00000400 81100000 01000000 0000fff0 
 0x040: 74400000 00000000 fc161dc7 00000000 004d1000 00000000 0088e51c 
 0x060: 1000000f 01e17809 00000000 00000000 00000704 000003c0 60f60c59 
Realtek station address 00:50:fc:96:33:90, chip type 'rtl8139C'.
  Receiver configuration: Reception disabled
     Rx FIFO threshold 16 bytes, maximum burst 16 bytes, 8KB ring
  Transmitter disabled with normal settings, maximum burst 16 bytes.
    Tx entry #0 status 00002000 incomplete, 0 bytes.
    Tx entry #1 status 00002000 incomplete, 0 bytes.
    Tx entry #2 status 00002000 incomplete, 0 bytes.
    Tx entry #3 status 00002000 incomplete, 0 bytes.
  Flow control: Tx disabled  Rx disabled.
  The chip configuration is 0x10 0x4d, MII full-duplex mode.
  No interrupt sources are pending.
Decoded EEPROM contents:
   PCI IDs -- Vendor 0x10ec, Device 0x8139.
   PCI Subsystem IDs -- Vendor 0x10ec, Device 0x8139.
   PCI timer settings -- minimum grant 32, maximum latency 64.
  General purpose pins --  direction 0xe5  value 0x12.
  Station Address 00:50:FC:96:33:90.
  Configuration register 0/1 -- 0x4d / 0xc2.
 EEPROM active region checksum is 0a28.
 The RTL8139 does not use a MII transceiver.
 It does have internal MII-compatible registers:
   Basic mode control register   0x1000.
   Basic mode status register    0x7809.
   Autonegotiation Advertisement 0x01e1.
   Link Partner Ability register 0x0000.
   Autonegotiation expansion     0x0000.
   Disconnects                   0x0000.
   False carrier sense counter   0x0000.
   NWay test register            0x0704.
   Receive frame error count     0x0000.

Help !


         panard@inzenet.org                http://www.inzenet.org