[realtek] Problem with Accton EN1207D-TX

[Ville Herva]

On Tue, Jan 09, 2001 at 11:20:21AM -0500, you [Donald Becker] claimed:
> On Tue, 9 Jan 2001, Ville Herva wrote:
> 
> > > I think that the next step should be to move the card to bus #0, likely one
> > > of the 64 bit slots.

Okay, I moved the card to the uppermost PCI slot (just below AGP), I think
that's #2. (Is it just me or are the 64-bit slots physically incompatible
with 32-bit cards? You can mount a 64-bit card to a 32-bit slot but not
the other way around.)

Here are the results:

root@terminator:/root>insmod pci-scan.o rtl8139.o
root@terminator:/root>dmesg
(...)
rtl8139.c:v1.12 9/14/2000 Donald Becker, becker@scyld.com.
 http://www.scyld.com/network/rtl8139.html
  The PCI BIOS has not enabled the device at 1/48!  Updating PCI command 0103->0107.
eth0: SMC1211TX EZCard 10/100 (RealTek RTL8139) at 0xa800, IRQ 10, 00:10:b5:05:21:ef.


root@terminator:/root>lspci -vv 
(...)
01:06.0 Ethernet controller: Accton Technology Corporation SMC2-1211TX (rev 10)
	Subsystem: Hewlett-Packard Company: Unknown device 9207
	Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B-
	Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
	Latency: 64 (8000ns min, 16000ns max)
	Interrupt: pin A routed to IRQ 10
	Region 0: I/O ports at a800
	Region 1: Memory at fc7ffc00 (32-bit, non-prefetchable)
	Expansion ROM at fc7e0000 [disabled]
(...)


root@terminator:/root>lspci -vv -n
(...)
01:06.0 Class 0200: 1113:1211 (rev 10)
	Subsystem: 103c:9207
	Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B-
	Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
	Latency: 64 (8000ns min, 16000ns max)
	Interrupt: pin A routed to IRQ 10
	Region 0: I/O ports at a800
	Region 1: Memory at fc7ffc00 (32-bit, non-prefetchable)
	Expansion ROM at fc7e0000 [disabled]
(...)

So does this mean the bus is broken?


-- v --

v@iki.fi