[eepro100] eth0: card reports no resources.

[Donald Becker]

On Tue, 30 Jul 2002, Andrew Pollock wrote:

> > The current version describe how to clear Sleep mode in the message.
> > 
> > http://www.scyld.com/diag/index.html
> >   ftp://ftp.scyld.com/pub/diag/
> Is it safe to run the program with the options to clear Sleep mode on
> a running interface?

Hmmm, pretty much, yes.
You should check that the EEPROM is actually changed after doing the write.
But the change won't take effect until the next full-power-down (not
just soft-power-off).

[[ If it was possible to make the change without hard-resetting the
board, I would have the driver patch up the problem. ]]

-- 
Donald Becker				becker@scyld.com
Scyld Computing Corporation		http://www.scyld.com
410 Severn Ave. Suite 210		Second Generation Beowulf Clusters
Annapolis MD 21403			410-990-9993