[eepro100] Intel PRO/100 S Dual Port Server adapter

[Andrew Pollock]

> What does /proc/pci report as the device and vendor IDs?  There should
> be two four digit numbers, and the vendor ID should be 0x8086

For your viewing pleasure:

Bus  1, device   4, function  0:
    Ethernet controller: Intel 82557 (rev 5).
      Medium devsel.  Fast back-to-back capable.  Master Capable.  No bursts. 
M
in Gnt=8.Max Lat=56.
      Prefetchable 32 bit memory at 0x0 [0x8].
      I/O at 0x5800 [0x5801].
  Bus  1, device   5, function  0:
    Ethernet controller: Intel 82557 (rev 5).
      Medium devsel.  Fast back-to-back capable.  Master Capable.  No bursts. 
M
in Gnt=8.Max Lat=56.
      Prefetchable 32 bit memory at 0x0 [0x8].
      I/O at 0x5820 [0x5821].

Also, from lspci -vv:

01:04.0 Ethernet controller: Intel Corporation 82557 [Ethernet Pro 100] (rev
05)
        Subsystem: Intel Corporation EtherExpress PRO/100+ Dual Port Adapter
        Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Step
ping- SERR- FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort
- <MAbort- >SERR- <PERR-
        Interrupt: pin A routed to IRQ 0
        Region 0: Memory at <unassigned> (32-bit, prefetchable) [disabled]
        Region 1: I/O ports at 5800
        Capabilities: [dc] Power Management version 1
                Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA
PME(D0+,D1+,D2+,D3hot
+,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-

01:05.0 Ethernet controller: Intel Corporation 82557 [Ethernet Pro 100] (rev
05)
        Subsystem: Intel Corporation EtherExpress PRO/100+ Dual Port Adapter
        Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Step
ping- SERR- FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort
- <MAbort- >SERR- <PERR-
        Interrupt: pin A routed to IRQ 0
        Region 0: Memory at <unassigned> (32-bit, prefetchable) [disabled]
        Region 1: I/O ports at 5820
        Capabilities: [dc] Power Management version 1
                Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA
PME(D0+,D1+,D2+,D3hot
+,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-

>From what I can determine, the card isn't being allocated an IRQ...

Andrew