eepro100 failure at boot: no resources

[Orion Poplawski]

If I remove the network cable after I see the stream of errors on the
console, the errors stop.  Can't access the console afterwards though -
probably in a bad state.

I suppose I may give the Intel driver a try.  Anyone have any experience
with it?

-----Original Message-----
From: owner-linux-eepro100@beowulf.org
[mailto:owner-linux-eepro100@beowulf.org]On Behalf Of Krawl, Roeland
Sent: Thursday, April 27, 2000 1:04 PM
To: 'Orion Poplawski'; linux-eepro100@beowulf.org
Subject: RE: eepro100 failure at boot: no resources


If your boot problem occurs when no network cable is attached (to your
Ethernet card) then obviously your "No RX buffers" message is not caused as
a result of receiving too many packets.


-------------------------------------------------------------------
To unsubscribe send a message body containing "unsubscribe"
to linux-eepro100-request@beowulf.org