eth0 errors reported on boot after improper shutdown

Jeremy Domingue jer@cybersurfers.net
Tue Apr 18 03:01:55 2000


Hey all,

Well, I have a very interesting problem that I'm hoping someone might be
able to give me some insight on. Let me start at the beginning..... we had a
prolonged power outage and one of our servers lost power without a proper
shutdown. When I finally got to a console and repowered the sucker, I had to
do a manual fsck on the drive and it found numerous problems, but all were
"corrected". Now, however, when I try to boot the server, when it gets to
loading the network driver and turning up the ethernet cards, it says "eth0:
card reports no RX buffers." and "eth0: card reports no resources." in what
appears to be an endless loop. I have tried to correct this to no avail. We
have 2 ethernet adapters in the server, and eth1 is fine.... I have tried
powering off and swapping the two cards to see if it's a hardware problem,
but eth0 still does the same thing when I swap the cards. I'm not even sure
where to begin on this one.... any insight would be greatly appreciated.
Here is what dmesg shows on boot:

Apr 17 21:04:35 hawk kernel: eepro100.c:v1.09j-t 9/29/99 Donald Becker
http://cesdis.gsfc.nasa.gov/linux/drivers/eepro100.html
Apr 17 21:04:35 hawk kernel: eepro100.c: $Revision: 1.18 $ 1999/12/29
Modified by Andrey V. Savochkin <saw@msu.ru>
Apr 17 21:04:35 hawk kernel: eth0: OEM i82557/i82558 10/100 Ethernet at
0xd0063000, 00:D0:B7:3E:BD:37, IRQ 14.
Apr 17 21:04:35 hawk kernel:   Receiver lock-up bug exists -- enabling
work-around.
Apr 17 21:04:35 hawk kernel:   Board assembly a08922-001, Physical
connectors present: RJ45
Apr 17 21:04:35 hawk kernel:   Primary interface chip i82555 PHY #1.
Apr 17 21:04:35 hawk kernel:   General self-test: passed.
Apr 17 21:04:35 hawk kernel:   Serial sub-system self-test: passed.
Apr 17 21:04:35 hawk kernel:   Internal registers self-test: passed.
Apr 17 21:04:35 hawk kernel:   ROM checksum self-test: passed (0x04f4518b).
Apr 17 21:04:35 hawk kernel: eth1: OEM i82557/i82558 10/100 Ethernet at
0xd0065000, 00:D0:B7:3E:B7:20, IRQ 10.
Apr 17 21:04:35 hawk kernel:   Receiver lock-up bug exists -- enabling
work-around.
Apr 17 21:04:35 hawk kernel:   Board assembly a08922-001, Physical
connectors present: RJ45
Apr 17 21:04:35 hawk kernel:   Primary interface chip i82555 PHY #1.
Apr 17 21:04:35 hawk kernel:   General self-test: passed.
Apr 17 21:04:35 hawk kernel:   Serial sub-system self-test: passed.
Apr 17 21:04:35 hawk kernel:   Internal registers self-test: passed.
Apr 17 21:04:35 hawk kernel:   ROM checksum self-test: passed (0x04f4518b).
Apr 17 21:04:35 hawk kernel: eth0: card reports no RX buffers.
Apr 17 21:04:35 hawk kernel: eth0: card reports no resources.

(last two lines loop until I shutdown)

TIA!

Jeremy Domingue
jer@cybersurfers.net

-------------------------------------------------------------------
To unsubscribe send a message body containing "unsubscribe"
to linux-eepro100-request@beowulf.org