question about Bonding tools

[Chris Greer]

Along this same thread...if you are using a cisco
switch do you enable source-based's port groups or
destination based port groups with a Linux box channel
bonded on the other end?

Chris G.

liuxg wrote:
> 
> hello ,Bill Northrup£¬,
> 
> ÔÚ 00-10-21 8:13:00 ÄúдµÀ£º
> >Hello,
> >
> >Etherchannel or bonding is a function of host and switch config, not vlan...
> >It appears your bonding on the host is ok, the switch needs to be configured
> >to bond those channels as well.
> >
> >
> >Bill
>   Does it mean the ports on the switch should configure as port tunkinng?
>   thanks
> 
>             liuxg
>             beowulf at eyou.com
> 
> _______________________________________________
> Beowulf mailing list
> Beowulf at beowulf.org
> http://www.beowulf.org/mailman/listinfo/beowulf