[3c509] Help me please!

[Madhav Diwan]

Try using the mii-tool program from scyld.com

if  you are using a new version of Suse  then the program may already be
installed  with your distribution .

 the man page for mii-tool  tells you how to do things

you could also get one of the 3com setup tools from scyld.com  I think
the vortex-diag program should be the one but check the site to be sure.

good luck

Madhav


On Wed, 2002-05-01 at 12:05, Dor S. wrote:

Hey,
I will tell my story in short, few days ago I've installed SuSE 8.0 with
a
3com 905B network card.
And i'm using the 3c59x module, but i'm having problems.
I think it might be becuase there was autonegoition and the module is
set to
100MBit, Full Duplex, and it should be only 10MBit, Half duplex.
I tried figuring how to do that, but failed.
How can I make the card act with the settings of 10MBit, Half Duplex?
Please help me :(

Thanks in advance!

-Dor

_______________________________________________
3c509 mailing list
3c509@scyld.com
http://www.scyld.com/mailman/listinfo/3c509