3c905 won't work

[Marc Roberts]

Hello,

I have trouble getting my 3c905-TX to work. The output of my boot is
listed below. I insmod the driver with debug=6 and options=6. The card
is connected to a 3Com Superstack II TX hub at 100Mhz. On the card the
10Mbps link indicator is on and the Activity indicator is on all the
time.
It's a dual boot machine with NT and linux and the card works perfectly
under NT. Can anyone help me?

3c59x.c:v0.99H 11/17/98 Donald Becker
http://cesdis.gsfc.nasa.gov/linux/drivers/vortex.html
eth0: 3Com 3c905 Boomerang 100baseTx at 0xff00,  00:60:08:4d:3d:ce, IRQ
9
  Internal config register is 16302d8, transceivers 0xe040.
  8K word-wide RAM 3:5 Rx:Tx split, autoselect/MII interface.
  Media override to transceiver type 6 (MII).
  MII transceiver found at address 24, status 7849.
  Enabling bus-master transmits and whole-frame receives.
eth0: Overriding PCI latency timer (CFLT) setting of 24, new value is
32.
JAVA Binary support v1.01 for Linux 1.3.98 (C)1996 Brian A. Lantz
PS/2 auxiliary pointing device detected -- driver installed.
eth0: Media override to transceiver 6 (MII).
eth0: Initial media type MII.
eth0: MII #24 status 7849, link partner capability 0000, setting
half-duplex.
eth0: vortex_open() InternalConfig 016302d8.
eth0: vortex_open() irq 9 media status 8802.
eth0:  Filling in the Rx ring.
eth0: Media selection timer tick happened, MII.
eth0: MII transceiver has status 7849.
eth0: Media selection timer finished, MII.