Problems getting 905b-tx into 100BaseT

[Donald Becker]

On Tue, 13 Apr 1999, Serge Ivanoff wrote:

> What software setting?
> 
> >You should be using the default setting, which is Autonegotiate, unless you
> >have a card with a BNC connector in which case you may also use the 10base2
> >override.
> I'm using default setting...
> Where is trouble?

The driver reported, in the start-up message, that the media type was
overridden.
This is set by the parameter 'options', when loaded as a module, or the
third boot paramter e.g. "ether=0,0,4,eth0" when the driver is built-in.

Donald Becker					  becker@cesdis.gsfc.nasa.gov
USRA-CESDIS, Center of Excellence in Space Data and Information Sciences.
Code 930.5, Goddard Space Flight Center,  Greenbelt, MD.  20771
301-286-0882	     http://cesdis.gsfc.nasa.gov/people/becker/whoiam.html