Message en plusieurs parties et au format MIME.
------=_NextPart_000_0018_01BF7656.CA05B560
Content-Type: multipart/alternative;
boundary="----=_NextPart_001_0019_01BF7656.CA05B560"
------=_NextPart_001_0019_01BF7656.CA05B560
Content-Type: text/plain;
charset="iso-8859-1"
Content-Transfer-Encoding: quoted-printable
I have some problem when trying to use the 3CCFE575CT card: 3c575_cb.o =
modules insertion pretty successes, device eth0 exists and ifconfig =
permits to configure it.
BUT both speed LEDs remain off.
"ifport eth0" reports: eth0 6 (100baseT4)
"mii-diag eth0" reports: 3100 7809 0300 e54b 01e1 0000 0000 0000 + Link =
status : not etablished
"ifconfig eth0" reports: Link encap: Ethernet HWaddr 00:50:DA:AE:CF:8B
inet addr: 192.0.0.2 Bcast: 192.0.0.255 =
Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST =
MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 =
overruns:0 frame:0
TX packets:0 errors:0 dropped:0 =
overruns:0 carrier:0
collisions:0 txqueuelen:100
interrupts:3 Base address:0x100
My hardware configuration is OK because it works with Windows95.
I use RedHat 6.0 + Linux 2.2.5-15 + pcmcia-cs-3.0.9
Help !
------=_NextPart_001_0019_01BF7656.CA05B560
Content-Type: text/html;
charset="iso-8859-1"
Content-Transfer-Encoding: quoted-printable
<!DOCTYPE HTML PUBLIC "-//W3C//DTD W3 HTML//EN">
I have some problem when trying to =
use the=20
3CCFE575CT card: 3c575_cb.o modules insertion pretty successes, =
device=20
eth0 exists and ifconfig permits to configure it.
BUT both speed LEDs remain off.
"ifport eth0" reports: =
eth0 6=20
(100baseT4)
"mii-diag eth0" reports: 3100 7809 0300 =
e54b 01e1=20
0000 0000 0000 + Link status : not etablished
"ifconfig =
eth0"=20
reports: Link encap: Ethernet HWaddr 00:50:DA:AE:CF:8B
&nbs=
p; =
; =20
inet addr: 192.0.0.2 Bcast: 192.0.0.255 Mask:255.255.255.0
&nbs=
p; =
; =20
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
&nbs=
p; =
; =20
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
&nbs=
p; =
; =20
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
&nbs=
p; =
; =20
collisions:0 txqueuelen:100
&nbs=
p; =
; =20
interrupts:3 Base address:0x100
My hardware configuration is OK because it works =
with=20
Windows95.
I use RedHat 6.0 + Linux 2.2.5-15 +=20
pcmcia-cs-3.0.9
Help !