[tulip] Compaq Presario laptop and tulip PCMCIA card

[Jesse F. Hughes]

Donald Becker <becker@scyld.com> writes:

> On 7 Mar 2002, Jesse F. Hughes wrote:
> This explains part of the problem: This is a new device ID.
> 
> Try adding the following new table entry to tulip.c.
> 
> 	{ "ADMtek Centaur-C (Linksys)", { 0xab0313d1, 0xffffffff },
> 	  TULIP_IOTYPE, TULIP_SIZE1, COMET },
> +	{ "ADMtek Centaur-C (Linksys)", { 0xab0813d1, 0xffffffff },
> +	  TULIP_IOTYPE, TULIP_SIZE1, COMET },
> 	{ "STMicro STE10/100 Comet", { 0x0981104a, 0xffffffff },
> 	  TULIP_IOTYPE, TULIP_SIZE1, COMET },
> 
> I've put this in v0.93b which will appear at
>     ftp://www.scyld.com/pub/network/test/tulip.c
> if you report that it works.

Hoo-doggies, that did it.  Thanks much.

Should I care that eth0, i82365 and my sound card all show up on IRQ
9?


-- 
Jesse Hughes
"ARE YOU READY TO MAKE A PARADIGM SHIFT AND CHANGE THE QUALITY
OF YOUR LIFE FOREVER?"  --from a spam I was not yet ready to 
	                  receive.