[tulip] error messages from updated driver

[Mate Wierdl]

Hi,

On my RedHat 7.0 I installed 

# rpm -q netdriver
netdriver-2.0-3

since the original tulip driver would not work with my Linksys Fast
Ethernet 10/100.  Now I randomly(?) get this message in syslog (and
console):

eth0: Too much work during an interrupt, csr5=0xfc674050.

Perhaps this is helpful

# dmesg|grep eth0
eth0: ADMtek Comet rev 17 at 0xc804a000, 00:20:78:04:DF:B1, IRQ 11.
eth0:  MII transceiver #1 config 1000 status 786d advertising 01e1.
eth0: Too much work during an interrupt, csr5=0xfc674050.

The processor is an AMD Athalon 600 (just purchased).

Thx,

Mate
---
Mate Wierdl | Dept. of Math. Sciences | University of Memphis