linksys cardbus 10/100 error

Remo Strotkamp remo@ccrl.nj.nec.com
Tue Mar 2 23:46:54 1999


Hi there,


I just tried to install my linksys 10/100 cardbus pcmcia card.

After following exactly what linksys mentioned at their homepage,
I get the following messages during booting:



Linux PCMCIA Card Services 3.0.9
  kernel build: 2.2.2 unknown
  options:  [pci] [cardbus] [apm]
Intel PCIC probe:
  TI 1131 PCI-to-CardBus at bus 0 slot 4, mem 0x68000000, 2 sockets
    host opts [0]: [clkrun irq 10] [pci + serial irq] [no pci irq] [lat 64/32] [bus 32/34]
    host opts [1]: [clkrun irq 10] [pci + serial irq] [no pci irq] [lat 64/32] [bus 35/37]
    ISA irqs (scanned) = 3,4,7,10,11,15 status change on irq 15
cs: IO port probe 0x1000-0x17ff: clean.
cs: IO port probe 0x0100-0x04ff: excluding 0x170-0x177 0x220-0x22f 0x370-0x37f 0x388-0x38f
0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: clean.
cs: cb_config(bus 32): vendor 0x1011, device 0x0019
  fn 0 bar 1: io 0x280-0x2ff
  fn 0 bar 2: mem 0xa00c0000-0xa00c03ff
  fn 0 rom: mem 0xa0080000-0xa00bffff
cs: cb_enable(bus 32)
  bridge io map 0 (flags 0x21): 0x280-0x2ff
  bridge mem map 0 (flags 0x1): 0xa0080000-0xa00c0fff
tulip_attach(bus 32, function 0)
tulip.c:v0.90 10/20/98 becker@cesdis.gsfc.nasa.gov
eth0: Digital DS21143 Tulip at 0x280, 00 80 00 80 00 80, IRQ 3.
eth0:  EEPROM default media type 10baseT.
cs: memory probe 0xa0000000-0xa0ffffff: excluding 0xa0000000-0xa00fffff
tty02 at 0x03e8 (irq = 10) is a 16550A
eth0: The transmitter stopped!  CSR5 is f0678006, CSR6 b3862002.
eth0: The transmitter stopped!  CSR5 is f0008102, CSR6 b2420200.
eth0: The transmitter stopped!  CSR5 is f0008102, CSR6 b2420200.
eth0: The transmitter stopped!  CSR5 is f0008102, CSR6 b2420200.



I think the beginning looks pretty good, but I have no clue what the 'transmitter stopped! CSR5...."

means, but does not look too good   :-(

Does this mean my linksys card is broken????


please help
my 3 weeks of Linux are far not sufficient for such stuff


remo