ethernet switch recommendation?
Many of your questions may have already been answered in earlier discussions or in the FAQ. The search results page will indicate current discussions as well as past list serves, articles, and papers.
Felix Rauch rauch at inf.ethz.chThu May 31 10:35:31 PDT 2001
- Previous message: ethernet switch recommendation?
- Next message: MPI performance test for Scyld
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
On Thu, 31 May 2001, Jarrod Smith wrote: > I've looked at the Cisco catalyst 2924XL, but at $1300, I'm not sure > it's the most economical solution that will get me what I need, > which is fairly basic I think. I'm not very familiar with Cisco-Switches, but we once had to use a Catalyst 2900 XL and it sucked. The performance was gone as soon as more then 12 machines were communicating at full speed *Therefore we could not use the switch to install all the nodes with our cloning tool Dolly at reasonable speeds). We didn't have these problems with ATI CentreCom 742i switches, but I think they are in "desktop" cases. There are some performance figures from our own tests comparing the two switches: http://www.inf.ethz.ch/~rauch/tmp/FE.Catalyst2900XL.Agg.pdf http://www.inf.ethz.ch/~rauch/tmp/FE.Catalyst2900XL.Stream.pdf http://www.inf.ethz.ch/~rauch/tmp/FE.CentreCom742i.Agg.pdf http://www.inf.ethz.ch/~rauch/tmp/FE.CentreCom742i.Stream.pdf Regards, Felix -- Felix Rauch | Email: rauch at inf.ethz.ch Institute for Computer Systems | Homepage: http://www.cs.inf.ethz.ch/~rauch/ ETH Zentrum / RZ H18 | Phone: ++41 1 632 7489 CH - 8092 Zuerich / Switzerland | Fax: ++41 1 632 1307
- Previous message: ethernet switch recommendation?
- Next message: MPI performance test for Scyld
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
More information about the Beowulf mailing list
