Beoboot-install help!

Mon Jan 22 21:57:40 PST 2001

Hi,

After doing a "beofdisk -w", you have to do a reboot for the partition
table to be written. On scyld software, you can reboot with
"bpctl -S <node_number> -s reboot"

That should get it to work.

Kian.

                    Nabeel Khan                                                                                              
                    <nkhan at mail.eecis        To:     beowulf at beowulf.org, becker at scyld.com                                   
                    .udel.edu>               cc:                                                                             
                    Sent by:                 Subject:     Beoboot-install help!                                              
                    beowulf-admin at beo                                                                                        
                    wulf.org                                                                                                 

                    01/22/2001 01:20                                                                                         
                    PM                                                                                                       

Hello again,
I am trying to install boot images to slave nodes... using Scyld Beowulf
installation with RedHat Linux V#7.0.
the scenario goes like this

#beoboot-install -a /dev/hda

unable to read partitions from slave nodes...

although i have successfully run the command that preceeds this one
that is

beoboot -q
beoboot -w

thanx
-nabeel

_______________________________________________
Beowulf mailing list
Beowulf at beowulf.org
http://www.beowulf.org/mailman/listinfo/beowulf